Using top of the range metrology grade laser scanning and 3D printing equipment we can ensure the products are designed for perfect operation and fitment. For example, our 3-bolt mounting flange aligns perfectly with the outside profile of the OE plastic mounting face.
Our thermostat housing is the only aftermarket housing you should run on your vehicle, unlike the competition we use the OEM dual plunger thermostat that ensures operation exactly like Honda intended. Other units actually reduce the efficiency of your cooling system by not using a dual plunger thermostat design which is there to gradually reduce and stop flow through the bypass port when things get hot. Also, plain steel is not used anywhere in our housings, this ensures that with our units you will not face orange rust covering all surfaces inside your engine and radiator, further reducing the efficiency of your cooling system.
Our t-stat housing is manufactured in the UK and the Nippon thermostat manufactured in Japan.
The unit is available with or without a radiator fan switch, if you chose without then it will be supplied with an M22 blanking plug and O-ring. The fan switch supplied is manufactured in the EU and are rated to over 1 million operations, we do not substitute on quality with our products! The fan switch turns on at 95c and off at 86c. If you do not need a fan switch, then the t-stat housing will be supplied with an M22 blanking plug and O-ring.
CNC machined from 6062-T6 billet aluminium.
Available with 32mm or AN16 hose fitting.
M22 x 1.5 port for radiator fan switch – perfect for k-swaps.
Swivel design alloys you to orient the housing for perfect fitment.
Uses original Honda dual-plunger thermostat & O-ring.
Allows the cooling system to function correctly with dual-plunger thermostat.
Some may note that there are no further ports on our housing, this is because there is no necessity to attach any extra sensors or hoses to the cold side of the t-stat housing. If you require a temperature reading for a gauge, then the correct position would be to mount the sensor on the outlet port on the head – this will give the most accurate reading.