SpeedFactory Racing's Toyota MR2 / Celica Titanium Stud Kits are made of ultra-strong Ti 6Al-4V and incorporate a 4mm hex key tip that allows them to be easily installed using an Allen wrench. Titanium 14mm 12-point nuts and washers are included.
The use of factory manifold bolts and studs, especially with an aftermarket header/turbo system, can result in stripped or broken bolts and inadequate clamping force, which can lead to leaks.
This stud kit looks great and will allow you to properly clamp your exhaust manifold to the cylinder head without experiencing sealing problems, common stud/nut failure, or ugly and troublesome rust and corrosion.
Titanium is ~45% lighter, stronger, and will not corrode like your stock steel bolts or studs!
Each stud/washer/nut assembly weighs only 14g!
Includes:
- 8 x M10 x 1.25mm x 55mm titanium studs
- 8 x 12-point M10x1.25mm titanium nuts
- 8 x M10 titanium washers
Available in standard or burnt titanium finish.
Installation Guide:
We have written a full guide for installing titanium intake or exhaust studs. This guide includes images of every step and a video if you would rather watch the installation process.
Just click the link here to head over to our installation page:
Titanium intake or exhaust studs installation guide
Fitment:
- Toyota Celica (1985-1998) with 3SGE/3SGTE engines, including All-Trac Turbo and GT-Four models
- Toyota MR2 (1990-1999) All Models
- Product Type:
- Titanium Exhaust Studs
- Manufacturer:
- Toyota
- Model:
- Mr2
- Model:
- Celica
- Engine:
- 3gse
- Engine:
- 3sgte
- Colour:
- Burnt
- Category:
- Exhaust System
